GUNAI Troubleshooting
My Cart 0
Recently added products

Total 0 products, total price: ¥0.00

Proceed to Checkout
Your cart is empty。

Troubleshooting common ebike issues. 

 

 

The power cannot be turned on, and the bicycle cannot work

 

 

1. First check whether the key is already in the position to turn on the bicycle. (There are three positions in total).Can the headlights and horn be used normally?

2. Check the appearance of the bicycle to see if there is any broken/short-circuited wires.

3. Check whether the power switch on the handlebar is normal. If it is hit or damaged, the switch needs to be replaced.

4. Check whether there are impurities or poor contact between the output port of the battery and the contact of the controller.

5. If you have a voltmeter, or your neighbor has a voltmeter, you can check whether the voltage of the battery output port is normal.

 

 

 

The power can be turned on, but the motor does not work

 

 

1. If there is no error code on the screen, please check if there is any damage to the motor cable.

2. Unplug the motor cable and plug it in again. (The interface of the motor cable is on the edge of the rear triangle of the frame.)

3. Enter the setting mode of the screen and check whether the parameters are set incorrectly. You can ask GUNAI customer service for the factory parameters.

 

 

 

Error code

 

 

1. If any error codes appear on your screen, please refer to the table on the next page.

2. We recommend that you replug and unplug the wires of the controller and the motor after any error code appears, because the error code is likely to be caused by loose wires.

3. *You need to pay attention to the operation one by one when you plug and unplug the wires again, so as not to forget how the wires are connected.

4. If the error code still exists after plugging and unplugging the cable, please take a photo of the error code displayed on the screen and send it to us, then we will solve the problem for you or provide you with effective suggestions.

5. When encountering any Error code, we suggest you contact our email or WhatsApp to facilitate sending photos/videos to each other.This is so that we can solve your problems faster and more effectively.

 

 

 

 

 

 

 

 

 

E-Code

Meaning

The Reason Why the E-code Appearance

 

E00

Normal status

Need to restart or replug the wire.

 

E02

Brake failure

The brake cable may be broken.

 

E06

Battery undervoltage

Battery voltage is too low or damaged.

 

E07

Motor failure

Loose motor cable plug

The motor is damaged.

 

E08

Throttle handle failure

Twisted the handle before turning on the screenLoose plugThe handle is damaged

 

E09

Controller failure

The controller is damaged.

 

E10

Communication (receive) failure

The controller is broken
The screen (instrument) is damaged.

 

E11

Communication (transmit) failure

The screen (instrument) wire is loose

The screen (instrument) is damaged.

 

E12

BMS failure

Need to replace the battery protection board.

 

E30

Protocol error

The parameter of P20 is not set to 0.

TROUBLESHOOTING